 |
Buss Assembly
FURNACE BUSS ASSEMBLY IN MAIN TRANSFORMER VAULT WHERE IT CONNECTS TO TRANSFORMER.
The thermogram shows a hot spot on the third bar from the...more
|
 |
Cable to Busbar Connection
This cable to busbar connection feeding a pump is excessively hot and needs attention.
|
 |
Computer Chip
This is a computer chip under test. ThermaCAM imaging radiometers provide instant identification of a fault.
|
 |
Engine Block
Cooling process in engine block molding.
|
 |
Glass
Looking through glass at 3.4 microns.
|
 |
Glass at 5.1 microns
Looking at glass surface temperature with a glass filter at 5.1 microns.
|
 |
Heated Car Seats
Inspecting heated car seats.
|
 |
Heater Shells
Internal refractory damage
|
 |
Heater tubes
This thermal image of horizontal tubes inside a gas-fired heater clearly reveals coke buildup in the center tubes.
|
 |
Hot Barrel (w/man)
This thermogram dramatically reveals the general manager of the garment dying facility leaning toward the 32 gallon drum of hot sodium hydrosulfite....more
|
 |
Mechanical and electrical equipment
The motor in the background is revealed by IR thermography to be much hotter than the one in the foreground,
which is operating under similar load...more
|
 |
Micro resistor
Micro resistor with faulty element.
|
 |
Microcircuit
ThermaCAM image of a microcircuit showing 7 micron leads. Faults even smaller than 7 microns can be detected. ThermaCAM systems can measure very...more
|
 |
Mold temperature
Mold temperature in an automotive seat.
|
 |
PC Board
PC board with overheating component.
|
 |
PC Board Hot Spot
Obvious hot spot on a PC board.
|
 |
Process equipment condition
This thermal image details a 499º F hot spot on this heat exchanger.The IR camera can also provide early warning of problems or incipient failures in...more
|
 |
Pulley System
Hot drive belts.
|
 |
Wafer Board
This is an annealing process for wafers. Thermography can quickly identify thermal irregularities on critical parts.
|
 |
Water Pump Starter
The heater portion of the starter had a reading of 188.7°F. The pump was also very hot, indicating that it is in need of...more
|
 |
Windshield Washer Fluid Pump
It appears the coupling has failed or is out of alignment.
|
